Up to Snow Good Snowglobe

I made this adorable little snowglobe using SVG files from http://www.svgcuts.com/.  Tutorial is below.

SVG Cuts COLLECTIONS USED:
* Pick a Pumpkin
* December Gifts
* Winter Chill
* French Quarter Ironwork
* Kate's Holiday Silhouettes
　
SUPPLIES USED:
* Transparency Film Sheet
* Martha Stewart Snow Lace 12x12 Paper Pad
* AC Cardstock
* Self Stick Rhinestones
* Snow Glitter
* Anastasia Vintage Buttons by Bazzill (for the top)
* Snowflake Dress it up Buttons
* Dimensional Foam Squares
* Wind Up Music Box (I found mine at my local craft store)
 * Tweezers


DIMENSIONS:
Pick a Pumpkin SVG Kit (Globe)
Little Orange Pumpkin.svg     11.″ wide              Transparency Film Sheet
Pumpkin With Lid.svg           4.5″ wide               Light Blue
(JUST THE LID)

December Gifts SVG Kit (Base of Globe)
Short Cyclinder Bottom.svg   6.2" wide              Light Blue
(bottom only and make sure to cut a small hole for the wind up key to stick out of in the back)

French Ironwork Flourishes SVG Collection
Fleur.svg                               0.69″ wide             (cut 4) White

Winter Chill SVG Kit (Large Snowflake Bottom)
Snowflake Bottom.svg           2″ wide                    Light Grey
Snowflake Middle.svg            2" wide                    Light Blue
Snowflake Top.svg                 2" wide                    White

Kate's Holiday Sihouettes SVG Kit
Ice Skating Figure.svg           1.35″ wide                Black
Ice Skating Clothes.svg         0.63″ wide                Light Blue
Ice Skating Shirt.svg              0.71" wide                Red
Ice Skating Skates.svg          0.30" wide                White
　
INSTRUCTIONS:
1. Cut all of the above svg files. Piece together the Skater, the large Snowflake, and the base of the Snowglobe (December Gifts Cyclinder).
2. Piece together Transparency Pumpkin leaving one side and the top of the pumpkin open. Using the foam diminsional squares, attach large snowflake to the bottom of the pumpkin.
3. Using the foam diminsional squares on each side of the Sihouette, attach to the center of the large snowflake. Glue pumpkin side shut, but leave the top open at this point.
4. Reaching in through the top of the pumpkin, dollop a small amount of glue on each side of the sihouette to cover the foam squares. Pour in snow glitter via the open top of the pumpkin. Shake to adhere glitter to dollops of glue. You can toss in a few snowflake buttons at this point to help cover the foam squares. Make sure figure is straight.
5. Wait about 2-6 hours depending on the amount of dolloped glue. (Waiting guarantees that the figure is dry and ready to be wiggled a bit without you worrying about it moving from the center or leaning to the front or back). Glue top of the pumpkin closed.
6. Glue together the light blue pumpkin pieces to create a small "lid" and add to the top of transparency pumpkin (globe) to cover up the glued closure. Add the Dress it up Snowflake buttons around the top edges, taking care to cover up any showing glue. Place self stick rhinestones to the center of the snowflake buttons. Glue the Bazzill Button to the top of the globe.
7. Attach French Fleurs around the sides of the base of the snowglobe, then add Dress It Up buttons between each Fleur. Place self stick rhinestones to the center of the fleurs and buttons.
8. Place wind up music box inside the cyclinder. Glue the Pumpkin/Globe to the cyclinder base. Hold until dry.

Judine  :)